First check inspect the belt, if its faulty,cracked ,broken,loose then replace it.
The drive belt (or belts) of a washing machine may become worn or damaged, causing noisy operation or stopping the washer entirely. A damaged drive belt is easy to replace. Remove the back panel of the washer to gain access to the belt. To remove the belt:
- Loosen the bolt on the motor bracket and move the motor to put slack in the belt.
- Remove the old belt and stretch a new one into place on the pulleys.
- To put tension on the new belt, use a hammer handle or a short pry bar to push the motor into position while you tighten the bolt in the adjustable bracket. The belt should have about 1/2 inch deflection when you press on it at the center point, midway between the pulleys. If the belt is too loose, it will slip on the pulleys, causing the machine to malfunction. If the belt is too tight, it will wear very quickly and will probably become so hot that it will start to smoke or smell.
This should give you some help, before replacing the drive belt.
Dishwasher fills with water even after turned off?
No spin problem on washing machine?
How to Level washing machine?
How to replace Water Pump on washing machine?
How to replace water inlet valve on washing machine?
How to replace electronic control board on
How to replace the heating element on dryer?
How to troubleshoot vibration on Washing machine?
How to install Drive Belt on washing machine?
How to access the interior components on Whirlpool washers?
Control Panel Lock on Washing Machines?
Washer Siphoning?
How to Check Drain Pump on Front Loader washing machine?
washing machine shows FH error on display ?
washing machine shows F11 error on display ?
SUDS error on washing machine?
Washing machine shows F05 error on display?
Washing machine shows F20 error on display?
Washing machine shows F29 error on display?
F21 Error Code on washing machine?
Washing machine shows F27 error on display?
Washing machine shows F09 error on display?
F21 Error Code on washing machine?
Washing machine shows F02 error on display?
How to Replace Agitator Dogs on washing machine?
Front load washing machine is leaking water?
Top load washing machine is leaking water?
How to troubleshoot water leaking from washing machine?
Door Jam PROBLEM on
How to replace gear case on washing machine?
How to install 3 prong or 4 prong power cord to electric range?
HOW TO REPLACE DRIVE BELT ON DRYER?
Washing machine will not run any cycle?
The drive belt (or belts) of a washing machine may become worn or damaged, causing noisy operation or stopping the washer entirely. A damaged drive belt is easy to replace. Remove the back panel of the washer to gain access to the belt. To remove the belt:
- Loosen the bolt on the motor bracket and move the motor to put slack in the belt.
- Remove the old belt and stretch a new one into place on the pulleys.
- To put tension on the new belt, use a hammer handle or a short pry bar to push the motor into position while you tighten the bolt in the adjustable bracket. The belt should have about 1/2 inch deflection when you press on it at the center point, midway between the pulleys. If the belt is too loose, it will slip on the pulleys, causing the machine to malfunction. If the belt is too tight, it will wear very quickly and will probably become so hot that it will start to smoke or smell.
This should give you some help, before replacing the drive belt.
FROM WHERE TO GET PARTS IF REQUIRED:----
Replacement parts can be purchased at any of the following web sites:
searspartsdirect.com
pcappliancerepair.com
appliancepartspros.com
repairclinic.com
searspartsdirect.com
pcappliancerepair.com
appliancepartspros.com
repairclinic.com
-------------------------
FOR more appliance troubleshooting help check the link below:---
For more help: ----Problem related to overfilling. Click the link below:--
No comments:
Post a Comment