washing machine shows F05 error on display?

Whirlpool Duet and Kenmore Elite model FRONT LOADERS displaying F05 Error Code.

WHY F05 ERROR CODE IS SEEN ON DISPLAY, WHAT DOES THIS ERROR CODE MEAN?

"F05" is an indication of a water temperature sensor (NTC) error, or Heating Circuit failure. Check the Water Temperature Sensor and check connections to the Water Temperature Sensor. To access, you will have to UNPLUG your washer and remove the lower access panel under the door. The panel comes off by removing the screws under the bottom edge. HINT: If you place a block of wood under each front foot of the washer, it will make access to the screws much easier. If the panel sticks, a tap on the sides will knock it free. The panel will drop down then come off. The sensor (NTC) is located at the base of the wash tub in the front on the heating element. This will be a small square shaped plug between the heating element terminals. Unplug the wire harness and take a resistance check. Readings will be as follows:

Temperature Meter Reading
32°F (0°C) 35.9 K ohms
86°F (30°C) 9.7 K ohms
104°F (40°C) 6.6 K ohms
122°F (50°C) 4.6 K ohms
140°F (60°C) 3.2 K ohms
158°F (70°C) 2.3 K ohms
203°F (95°C) 1 K ohms

Roughly...around 9K ohms at room temperature if I'm reading the chart correctly. Take readings as listed and also double check the connector to make sure it is not oxidized. Try cleaning the plug and reconnecting to see if the error code goes away. If not, you will probably have to replace the sensor. If the sensor checks good, take a reading across the heating element terminals. It should indicate about 15 ohms.

Lastly, remove the washer top panel by removing the three screws holding the panel in place in the rear.Once the screws are removed, slide the panel back then off. Locate the Central Control Unit (CCU) directly behind the wash tub. Take a resistance check at the Heating Element Solenoid by removing connector 9 from the CCU (this is the second connector from the RIGHT as facing from the front). A reading across test points 1 & 2 should also read 15 ohms.

-----------------

Replacement parts can be purchased at any of the following web sites:

searspartsdirect.com
pcappliancerepair.com
appliancepartspros.com
repairclinic.com

-----------

FOR more appliance troubleshooting help check the link below:---

For more help: ----Problem related to overfilling. Click the link below:--

Dishwasher fills with water even after turned off?

Washing machine fills with water even after turned off?

How to repair direct drive washing machines?

How to replace motor coupling on washing machines?

· Constant Beep on Kenmore Oasis washer?

· How to replace Clutch on Whirlpool Top Load washe...

· How to replace Glass Cook Top?

· how to troubleshoot an "Fdl" error code on washing...

· Using Regular Detergent on HE Washer?

· Washing machine error codes?

· Ceramic Glass Cooktops?

· How to Winterize the Washing Machine?

· How To replace the Agitator and Dogs on Kenmore S...

· Error HE3 on Kenmore Elite Quiet washer?

· ERROR F02 on Hotpoint Aquarius washer dryer

· Error F-28 on Maytag Whirlpool frontload?

· Error F-21 on Maytag Whirlpool frontload?

· How to check Drain Pump on Kenmore Elite Front Loa...

· SUD and F35 error code on Kenmore Elite washer?

· washing cycles are taking up too long to complete ...

· AF error on whirlpool cabrio?

· DE error on LG washing machine

· HC error code on Top Load Washer

· f7 error code and beeping on kenmore single elect...

Error F06 on Frigidaire Front Load Washer

How to check Drain Pump on Whirlpool Cabrio washer...

No spin problem on washing machine?

http://washingmachineforum.blogspot.com/2011/09/no-spin-problem-on-washing-machine.html

How to Level washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-level-washing-machine.html

How to replace Water Pump on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-water-pump-on-washing.html

How to replace water inlet valve on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-water-inlet-valve-on.html

How to replace electronic control board on Kitchen Range?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-electronic-control-board.html

How to replace the heating element on dryer?

http://schematicsdiagram.blogspot.com/2011/09/how-to-replace-heating-element-on-dryer.html

How to troubleshoot vibration on Washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-troubleshoot-vibration-on.html

How to install Drive Belt on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-install-drive-belt-on-washing.html

How to access the interior components on Whirlpool washers?

http://washingmachineforum.blogspot.com/2011/09/how-to-access-interior-components-on.html

Control Panel Lock on Washing Machines?

http://washingmachineforum.blogspot.com/2011/09/control-panel-lock-on-washing-machines.html

Washer Siphoning?

http://washingmachineforum.blogspot.com/2011/09/washer-siphoning.html

How to Check Drain Pump on Front Loader washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-check-drain-pump-on-front-loader.html

washing machine shows FH error on display ?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-fh-error-on.html

washing machine shows F11 error on display ?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f11-error-on.html

SUDS error on washing machine?

http://washingmachineforum.blogspot.com/2011/09/suds-error-on-washing-machine.html