Thursday, September 29, 2011

Top load washing machine is leaking water ?

My washing machine is leaking water?

To determine the location of a leak. Just follow these steps to access the interior to determine where the leak may be coming from:

1. Unplug washing machine.

2. Remove console. This can be accomplished in one of two ways depending on which type of console you have.

a. If the console has removable end caps, the caps lift off by prying on the top from the back of the washer. The cap will pull off towards you as you are facing the unit from the front of the washer. There will be a screw under each end cap that you will need to remove.

b. If the console does not have removable end caps, you will need to slide a putty knife under the front corner of each side and push in while lifting up. There is a retaining clip under each side that has to be released.

3. Once the console has been released it will lift up and fold back over the back of the washer in its resting position. Use care not to stress the small plastic hinges that hold it on. They can break easily.

4. Under the console will be two large brass colored clips. Take a large flat blade screwdriver and place it in the groove of the clip on the washer top. With the screwdriver firmly in the groove, push away from you towards the back of the washer. This will release the clips.

5. Disconnect the lid switch connector plug. This is the white colored plug on the washer top under the console.

6. Remove the washer casing. Open the lid of the washer. Using one hand, grip under the front rim of the washer opening. Do not grab the wash tub, just the casing. Tilt the washer case from the back first towards you, slide forward slightly, and then lift up. The entire case comes off exposing the wash tub and components.


OK.BUT IF THE LEAK IS COMING FROM FRONT SIDE THEN?

If the leak is coming from the front of the washer, most commonly this is caused by a leaking drain pump. The pump is located in the front directly below the wash tub. The pump is not serviceable and must be replaced if it is damaged.

Some other items to consider:

1. Check your fill hoses to ensure they are tight and not leaking. What can often appear as a washer problem, may be a loose hose.

2. With the washer case removed, check the area UNDER the wash tub. If the leak is coming from the center above the transmission, the tub seal may be leaking.

3. Inspect the wash tub for any cracks. If the tub is cracked and its not serious, you may be able to get by with some marine epoxy to reseal it. If the crack is significant, a new tub will be required.

4. If the water is gushing out of the bottom of the washer, check the air dome on the lower right hand side of the wash tub. This is a small plastic air hose that runs from the wash tub all the way to the pressure switch. If this hose comes loose, the washer will start to leak as it fills. Simply reattach if it comes loose.


NOTE: The ends on the air hose can become stretched over time. If you have enough slack in the hose, you can snip off a small portion of the end and reattach it to make sure it fits snug. If not, attach the hose to the air dome and place a zip tie around it where it connects to the air dome fitting. Make the zip tie snug enough to keep the hose from slipping off. Do not overtighten.

If you need an illustration of your washer and components, searspartsdirect.com, appliancepartspros.com, or pcappliancerepair.com usually have some excellent exploded view diagrams that you can refer to.

If you determine the pump is damaged and needs replaced, the following link explains how:

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-water-pump-on-washing.html


AFTER ALL THIS IS DONE,HOW CAN I INSTALL EVERYTHING BACK?


To reinstall the washer casing, follow these steps to ensure you get the case correctly placed and secure on the frame:

1. With the lid of the washer open, grasp case under front rim and place it on the washer frame. While looking down through the washer lid opening, make sure the front lip of the case is placed UNDER the washer frame and rocked back onto the frame to ensure that the small cleats on the frame fit into the slotted grooves on the washer case base. If you do not get the case seated correctly it will rattle and vibrate while the washer is in operation.

2. Make sure the back of the washer fits into the washer casing on each side by leaning over the front of the washer and grasping the back panel and pull towards you. Reinsert the brass clips by placing the clips into the slot on the back of the washer first, and then forcefully push then down into the opening on top of the washer.

3. REINSTALL LID SWITCH CONNECTOR. It is easy to forget. If you do not reconnect it, the washer will not work correctly.

4. Reinstall console.

----------

ANY HELPING TIPS BEFORE FOLLOWING THIS PROCEDURE?


READ THE PROCEDURE THOROUGHLY AND UNDERSTAND IT, BEFORE STARTING THE REPAIRS.

BASIC HOUSEHOLD TOOLS LIKE SCREWDRIVER, PLIERS, PRIER, PUTTY KNIFE ETC ETC ARE REQUIRED. ---

ALWAYS KEEP MARKER AND HANDY-CAM READY, WHILE PERFORMING THESE JOBS.

MARKER COMES IN USE TO MARK THE POSITION OR PARTICULAR WIRE OR SCREW AND HANDY CAM COMES IN USE FOR GETTING THE EXACT PICTURE OF PART,WHEN IT WAS ASSEMBLED, SO WHILE DIS-ASSEMBLY, YOU CAN JUST VIEW THE PICTURE/PHOTO AND THAT HELPS YOU A LOT.


FOR more appliance troubleshooting help check the link below:---

For more help: ----Problem related to overfilling. Click the link below:--

Dishwasher fills with water even after turned off?

Washing machine fills with water even after turned off?

How to repair direct drive washing machines?

How to replace motor coupling on washing machines?

· Constant Beep on Kenmore Oasis washer?

· How to replace Clutch on Whirlpool Top Load washe...

· How to replace Glass Cook Top?

· how to troubleshoot an "Fdl" error code on washing...

· Using Regular Detergent on HE Washer?

· Washing machine error codes?

· Ceramic Glass Cooktops?

· How to Winterize the Washing Machine?

· How To replace the Agitator and Dogs on Kenmore S...

· Error HE3 on Kenmore Elite Quiet washer?

· ERROR F02 on Hotpoint Aquarius washer dryer

· Error F-28 on Maytag Whirlpool frontload?

· Error F-21 on Maytag Whirlpool frontload?

· How to check Drain Pump on Kenmore Elite Front Loa...

· SUD and F35 error code on Kenmore Elite washer?

· washing cycles are taking up too long to complete ...

· AF error on whirlpool cabrio?

· DE error on LG washing machine

· HC error code on Top Load Washer

· f7 error code and beeping on kenmore single elect...

Error F06 on Frigidaire Front Load Washer

How to check Drain Pump on Whirlpool Cabrio washer...

No spin problem on washing machine?

http://washingmachineforum.blogspot.com/2011/09/no-spin-problem-on-washing-machine.html

How to Level washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-level-washing-machine.html

How to replace Water Pump on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-water-pump-on-washing.html

How to replace water inlet valve on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-water-inlet-valve-on.html

How to replace electronic control board on Kitchen Range?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-electronic-control-board.html

How to replace the heating element on dryer?

http://schematicsdiagram.blogspot.com/2011/09/how-to-replace-heating-element-on-dryer.html

How to troubleshoot vibration on Washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-troubleshoot-vibration-on.html

How to install Drive Belt on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-install-drive-belt-on-washing.html

How to access the interior components on Whirlpool washers?

http://washingmachineforum.blogspot.com/2011/09/how-to-access-interior-components-on.html

Control Panel Lock on Washing Machines?

http://washingmachineforum.blogspot.com/2011/09/control-panel-lock-on-washing-machines.html

Washer Siphoning?

http://washingmachineforum.blogspot.com/2011/09/washer-siphoning.html

How to Check Drain Pump on Front Loader washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-check-drain-pump-on-front-loader.html

washing machine shows FH error on display ?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-fh-error-on.html

washing machine shows F11 error on display ?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f11-error-on.html

SUDS error on washing machine?

http://washingmachineforum.blogspot.com/2011/09/suds-error-on-washing-machine.html

Washing machine shows F05 error on display?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f05-error-on.html

Washing machine shows F20 error on display?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f20-error-on.html

Washing machine shows F29 error on display?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f29-error-on.html

F21 Error Code on washing machine?

http://washingmachineforum.blogspot.com/2011/09/f21-error-code-on-washing-machine.html

Washing machine shows F27 error on display?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f27-error-on.html

Washing machine shows F09 error on display?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f09-error-on.html

F21 Error Code on washing machine?

http://washingmachineforum.blogspot.com/2011/09/f21-error-code-on-washing-machine.html

Washing machine shows F02 error on display?

http://washingmachineforum.blogspot.com/2011/09/washing-machine-shows-f02-error-on.html

How to Replace Agitator Dogs on washing machine?

http://washingmachineforum.blogspot.com/2011/09/how-to-replace-agitator-dogs-on-washing.html


Front load washing machine is leaking water ?

http://washingmachineforum.blogspot.com/2011/09/front-load-washing-machine-is-leaking.html

3 comments:

  1. Very useful post, not only for people who are into washing machine service but also for customers as they can learn from this post and try to rectify the issue themselves. Keep posting more on other washing machine service issues as well.

    ReplyDelete
  2. Thanks for the post. Definitely good for people who are into washing machine service.

    ReplyDelete
  3. Was searching all over the net to find solution for this washing machine dryer problem. Good post. Thank you.

    ReplyDelete